Ben I have put the address of my interface
Regards Feroze On Fri, Apr 8, 2016 at 7:39 PM, Benjamin Cropley <benjamin.crop...@gmail.com > wrote: > Feroze > > Can I just check.. in the listen variable have you put the address of your > interface or 1.2.3.4? > > You need to put your address.. not 1.2.3.4.... > > On Fri, Apr 8, 2016 at 3:30 PM, feroze waris <feroze.chaud...@gmail.com> > wrote: > >> Hi ben >> >> As you said i have enabled the listen=tls:1.2.3.4:5061 on receiving >> proxy as well. Now i am getting the following error in this case >> >> Apr 8 14:08:12 localhost OPENSIPS[623]: ERROR:tm:msg_send: send() for >> proto 3 failed >> Apr 8 14:08:12 localhost OPENSIPS[623]: ERROR:tm:t_forward_nonack: >> sending request failed >> Apr 8 14:08:12 localhost OPENSIPS[623]: ERROR:tm:w_t_relay: >> t_forward_nonack failed >> >> >> regards >> Feroze >> >> On Fri, Apr 8, 2016 at 1:15 PM, Benjamin Cropley < >> benjamin.crop...@gmail.com> wrote: >> >>> Feroze, >>> >>> I think you misunderstood :) >>> >>> I was saying, the URI has ;transport=tls, but the receiving server >>> probably doesn't have a port open to listen for it.. Don't remove this if >>> you want to use TLS, as by using rewrite() you're effectively breaking TLS >>> ;) >>> >>> In the documentation it says if you dont specify a listen= variable, >>> then it will listen on 'all interfaces'. It doesn't say whether it will >>> listen to UDP TCP and TLS. But I would guess it's possibly only UDP and TCP. >>> >>> Therefore, make sure on the servers receiving the packets that you >>> specifically set a tls listening interface with listen = tls: >>> 1.2.3.4:5061 >>> >>> Good luck >>> Ben >>> >>> >>> On Fri, Apr 8, 2016 at 7:29 AM, feroze waris <feroze.chaud...@gmail.com> >>> wrote: >>> >>>> Hi ben >>>> >>>> I have checked the traces and you were right that there was transport = >>>> tls in RURI when request forwards from load balancer to 2 opensips >>>> instances . I have replaced the RURI using rewrite() function and removed >>>> the transport parameter but the issue remains and i am getting the same >>>> error >>>> >>>> >>>> regards >>>> Feroze >>>> >>>> On Thu, Apr 7, 2016 at 1:09 PM, Benjamin Cropley < >>>> benjamin.crop...@gmail.com> wrote: >>>> >>>>> Wild guess here, based on what I've read.. >>>>> >>>>> It might be your request URI is explicitly declaring which protocol to >>>>> use, and OpenSIPS has no interface configured for that protocol.. eg. >>>>> ;transport=tls is added to the request URI but there's no listen = tls: >>>>> 1.2.3.4:5061 >>>>> >>>>> I know it's tricky to look at a trace for TLS. But have a look at >>>>> http://wiki.snom.com/FAQ/How_to_decode_TLS_calls_using_wireshark >>>>> >>>>> Good luck >>>>> Ben >>>>> >>>>> On Wed, Apr 6, 2016 at 6:24 PM, feroze waris < >>>>> feroze.chaud...@gmail.com> wrote: >>>>> >>>>>> Hi ben >>>>>> >>>>>> yes i am load balancing the Register and Invite request to two proxy >>>>>> servers using dispatcher module but all three servers (i.e load balncer >>>>>> and >>>>>> two opensips servers) are sharing same opensips database. >>>>>> This issue is not occurring in UDP call but on TLS this error occurs. >>>>>> >>>>>> Regards >>>>>> Feroze >>>>>> >>>>>> On Wed, Apr 6, 2016 at 7:34 PM, Benjamin Cropley < >>>>>> benjamin.crop...@gmail.com> wrote: >>>>>> >>>>>>> Feroze, >>>>>>> >>>>>>> Are you load balancing REGISTER *and *INVITE requests to different >>>>>>> nodes? >>>>>>> >>>>>>> If so, then unless you share location information between the >>>>>>> Registrars, then they wont all know where to route INVITEs. >>>>>>> >>>>>>> Ben >>>>>>> >>>>>>> >>>>>>> On Wed, Apr 6, 2016 at 3:20 PM, feroze waris < >>>>>>> feroze.chaud...@gmail.com> wrote: >>>>>>> >>>>>>>> Hello >>>>>>>> >>>>>>>> I have one load balancer connected to 2 opensips server >>>>>>>> Request is balancing through dispatcher module on load balancer >>>>>>>> the problem is when Register request of B party lands on different >>>>>>>> server than that server at which A Party sends invite request the call >>>>>>>> drops and i am getting following error >>>>>>>> Apr 6 07:58:31 localhost OPENSIP[1793]: ERROR:tm:update_uac_dst: >>>>>>>> failed to fwd to af 2, proto 3 (no corresponding listening socket) >>>>>>>> Apr 6 07:58:31 localhost OPENSIP[1793]: ERROR:tm:t_forward_nonack: >>>>>>>> failure to add branches >>>>>>>> Apr 6 07:58:31 localhost OPENSIP[1793]: ERROR:tm:w_t_relay: >>>>>>>> t_forward_nonack failed >>>>>>>> >>>>>>>> I am using Openisps version 2.1.1 and using TLS on it >>>>>>>> >>>>>>>> >>>>>>>> Regards >>>>>>>> Feroze >>>>>>>> >>>>>>>> _______________________________________________ >>>>>>>> Users mailing list >>>>>>>> Users@lists.opensips.org >>>>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >>>>>>>> >>>>>>>> >>>>>>> >>>>>>> _______________________________________________ >>>>>>> Users mailing list >>>>>>> Users@lists.opensips.org >>>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >>>>>>> >>>>>>> >>>>>> >>>>>> _______________________________________________ >>>>>> Users mailing list >>>>>> Users@lists.opensips.org >>>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >>>>>> >>>>>> >>>>> >>>>> _______________________________________________ >>>>> Users mailing list >>>>> Users@lists.opensips.org >>>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >>>>> >>>>> >>>> >>>> _______________________________________________ >>>> Users mailing list >>>> Users@lists.opensips.org >>>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >>>> >>>> >>> >>> _______________________________________________ >>> Users mailing list >>> Users@lists.opensips.org >>> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >>> >>> >> >> _______________________________________________ >> Users mailing list >> Users@lists.opensips.org >> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >> >> > > _______________________________________________ > Users mailing list > Users@lists.opensips.org > http://lists.opensips.org/cgi-bin/mailman/listinfo/users > >
_______________________________________________ Users mailing list Users@lists.opensips.org http://lists.opensips.org/cgi-bin/mailman/listinfo/users