Hi Dan, Thank you very much. how do I specify the audio file in the dial-peer?
My IOS on the gateway doesn't have progress_ind alert enable 8 for pots Once again, thanks a lot. On 9/24/07, Dan-Cristian Bogos <[EMAIL PROTECTED]> wrote: > > Hey Klaus/Mark, > > here is the configuration I have used in the past. It has been a > while, so I do hope I remember it corectly: > > In dial-peer voip (the one routing the call coming from pstn to media > streaming source: > > dial-peer voice 10000 voip > destination-pattern 10.... > progress_ind setup enable 3 This command should force the gateway considering that the call came > from PSTN with a progress indicator = 3 in the setup message, which > should be interpreted that the originator is non isdn and inband > messages are expected. > Alternatively, one could also force an incoming pots dial-peer match, > which will do some additional work by forcing the cut-through in one > way (progress_ind alert enable 8): > > dial-peer voice 1000 pots > destination-pattern 10.... > progress_ind setup enable 3 > progress_ind alert enable 8 > > I have found out that in some of the ios-es both commands are marked > as hidden, so don't worry if you don't get them by using the famous > '?' after progress_ind command. > Hope that helps. > > Cheers, > DanB > > On 9/22/07, Klaus Darilion <[EMAIL PROTECTED]> wrote: > > Dan-Cristian Bogos wrote: > > > Hi Guys, > > > > > > I also have done it and it worked like a charm. > > > I could even queue streams (more steps), all being played inband, > > > therefore no charge from PSTN side. > > > It all depends on your carrier whether he (or his partners) will open > > > one way channel on PSTN side or generate his own stuff when receiving > > > Progress indicator on ISDN (#C7) side - even Cisco ASes have this > > > option built in as a dial-peer command. > > > > > > Cheers, > > > DanB > > > > > > > > > On 9/22/07, Klaus Darilion <[EMAIL PROTECTED]> wrote: > > >> Mark Anthony C. Delfin wrote: > > >>> Hi all, > > >>> > > >>> Is it possible to alter ring back tone on cisco gateways. For > example I > > >>> want change my ringback to an audio file. Some Mobile providers do > this > > >>> already. > > >> > > >> I once tried that too on a 5300 - streaming early media into the > PSTN. > > >> From reading the docs I came to the conclusion that it should be > > >> possible but I could never test it as usually PRI are not allowed to > > >> stream early media to the PSTN. > > > > Hi Dan! Could you be a be more detailed how this is done in the gateway? > > I once did it with a tcl script and it was very complicated. > > > > regards > > klaus > > >
_______________________________________________ Users mailing list Users@openser.org http://openser.org/cgi-bin/mailman/listinfo/users