On Sat, Oct 3, 2020 at 6:33 PM Gianluca Cecchi <[email protected]> wrote:
> Sorry I see that there was an error in the lsinitrd command in 4.4.2, > inerting the "-f" position. > Here the screenshot that shows anyway no filter active: > > https://drive.google.com/file/d/19VmgvsHU2DhJCRzCbO9K_Xyr70x4BqXX/view?usp=sharing > > Gianluca > > > On Sat, Oct 3, 2020 at 6:26 PM Gianluca Cecchi <[email protected]> > wrote: > >> On Sat, Oct 3, 2020 at 4:06 PM Amit Bawer <[email protected]> wrote: >> >>> From the info it seems that startup panics because gluster bricks cannot >>> be mounted. >>> >>> >> Yes, it is so >> This is a testbed NUC I use for testing. >> It has 2 disks, the one named sdb is where ovirt node has been installed. >> The one named sda is where I configured gluster though the wizard, >> configuring the 3 volumes for engine, vm, data >> >> The filter that you do have in the 4.4.2 screenshot should correspond to >>> your root pv, >>> you can confirm that by doing (replace the pv-uuid with the one from >>> your filter): >>> >>> #udevadm info >>> /dev/disk/by-id/lvm-pv-uuid-DXgufc-7riC-TqhU-f8yH-EfZt-ivvH-TVcnEQ >>> P: >>> /devices/pci0000:00/0000:00:1f.2/ata2/host1/target1:0:0/1:0:0:0/block/sda/sda2 >>> N: sda2 >>> S: disk/by-id/ata-QEMU_HARDDISK_QM00003-part2 >>> S: disk/by-id/lvm-pv-uuid-DXgufc-7riC-TqhU-f8yH-EfZt-ivvH-TVcnEQ >>> >>> In this case sda2 is the partition of the root-lv shown by lsblk. >>> >> >> Yes it is so. Of course it works only in 4.4.0. In 4.4.2 there is no >> special file created of type /dev/disk/by-id/.... >> See here for udevadm command on 4.4.0 that shows sdb3 that is the >> partition corresponding to PV of root disk >> >> https://drive.google.com/file/d/1-bsa0BLNHINFs48X8LGUafjFnUGPCsCH/view?usp=sharing >> >> >> >>> Can you give the output of lsblk on your node? >>> >> >> Here lsblk as seen by 4.4.0 with gluster volumes on sda: >> >> https://drive.google.com/file/d/1Czx28YKttmO6f6ldqW7TmxV9SNWzZKSQ/view?usp=sharing >> >> ANd here lsblk as seen from 4.4.2 with an empty sda: >> >> https://drive.google.com/file/d/1wERp9HkFxbXVM7rH3aeIAT-IdEjseoA0/view?usp=sharing >> >> >>> Can you check that the same filter is in initramfs? >>> # lsinitrd -f /etc/lvm/lvm.conf | grep filter >>> >> >> Here the command from 4.4.0 that shows no filter >> >> https://drive.google.com/file/d/1NKXAhkjh6bqHWaDZgtbfHQ23uqODWBrO/view?usp=sharing >> >> And here from 4.4.2 emergency mode, where I have to use the path >> /boot/ovirt-node-ng-4.4.2-0..../initramfs-.... >> because no initrd file in /boot (in screenshot you also see output of "ll >> /boot) >> >> https://drive.google.com/file/d/1ilZ-_GKBtkYjJX-nRTybYihL9uXBJ0da/view?usp=sharing >> >> >> >>> We have the following tool on the hosts >>> # vdsm-tool config-lvm-filter -y >>> it only sets the filter for local lvm devices, this is run as part of >>> deployment and upgrade when done from >>> the engine. >>> >>> If you have other volumes which have to be mounted as part of your >>> startup >>> then you should add their uuids to the filter as well. >>> >> >> I didn't anything special in 4.4.0: I installed node on the intended >> disk, that was seen as sdb and then through the single node hci wizard I >> configured the gluster volumes on sda >> >> Any suggestion on what to do on 4.4.2 initrd or running correct dracut >> command from 4.4.0 to correct initramfs of 4.4.2? >> >> BTW: could in the mean time if necessary also boot from 4.4.0 and let it >> go with engine in 4.4.2? >> >> Thanks, >> Gianluca >> > Two many photos... ;-) I used the 4.4.0 initramfs. Here the output using the 4.4.2 initramfs https://drive.google.com/file/d/1yLzJzokK5C1LHNuFbNoXWHXfzFncXe0O/view?usp=sharing Gianluca
_______________________________________________ Users mailing list -- [email protected] To unsubscribe send an email to [email protected] Privacy Statement: https://www.ovirt.org/privacy-policy.html oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ List Archives: https://lists.ovirt.org/archives/list/[email protected]/message/UEWNQHRAMLKAL3XZOJGOOQ3J77DAMHFA/
