Dave,
Who knows .. perhaps the same company makes "all" the motorcycle
sending units in the world and you might luck out as far as matching
the mounting pattern. Most auto and boat units mount from the top ...
so you would probably be wasting your time ...
Seriously ... you know you don't really have a "rats" chance of it
matching .. so you might as well get a Bandit unit since it is a
"real" motorcycle unit, (which hopefully mounts from the bottom).
If it doesn't match your mounting pattern .. then take it and have a
square plate fabricated to match the new unit. Then take the "new"
plate and the gas tank to a welder and have them open up the old
mounting hole and weld your new plate on top of the opening ... then
... wala ... your done ....... hopefully ... IMHO ... How about the
fabrication shop where Zilla was born ?? Can't you take your tank in
there .. wave green stuff and say "make this fit .. I'll be back after
lunch" ??
campbell
----- Original Message -----
From: "david brilliandt" <[EMAIL PROTECTED]>
Subject: Re: How to change the fuel sending unit
> Now...the Stack/PDQ people say use any sending
> unit from a bike or auto (suggested a Suz. Bandit)
> that runs a graduated gauge.
> snip <
> How do I know the dang thing is gonna fit?
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
