Klaus, thanks for the info and explanation... I did manage to get it working. However, there's a few things you mentioned below that I did not do and it still works. Also, I might add, the explanation you just pointed out below should go into the user doc. I read through the networking section of the user doc and it good BUT just the way you explain what should or should not be configured from the host and the guess network adapter cleared things up. If that could go in the doc with a little polish explanation it will not leave users guessing.
Thanks for the HELP!!! Joe On 8/14/07, Klaus Espenlaub <[EMAIL PROTECTED]> wrote: > > This sounds correct, but it's hard to say for sure from such a short > description. Network configs are always a biteasier to get slightly > wrong than completely correct. > > You only need to configure the IP info of the bridge with what > previously was the config of the host. The real network card (and the > VBOX Host Interface" virtual network card) need not be configured. > > If everything works correctly, you should be able to ping everything, > and assuming you have a DHCP server on your LAN you should even be able > to let the guest use DHCP. > > Is the host working correctly? Does it have internet access after > configuring the bridge? > > -- > Dr. Klaus Espenlaub innotek GmbH, http://www.innotek.de > > _______________________________________________ > vbox-users mailing list > [email protected] > http://vbox.innotek.de/mailman/listinfo/vbox-users >
_______________________________________________ vbox-users mailing list [email protected] http://vbox.innotek.de/mailman/listinfo/vbox-users
