В сообщении от 30 September 2008 09:08:59 Niels Wagenaar написал(а): > Op Zo, 28 september, 2008 23:29, schreef gimli: > > Hi, > > > > I'm on Astra 19.2 and tested the following HD transponders : > > Anixe HD > > Arte HD > > Astra HD+ > > > > first test results : > > > > Arte HD tunes ok and plays fine. > > Same here. Arte HD is a DVB-S2 transponder using the 8PSK modulation. > Locking goes without any problems at all. > > > On Astra HD+ and Anixe HD im getting an error : > > Astra HD+ en Anixe HD is on a DVB-S2 transponder which is using a QPSK > modulation. > > > -- SNIP -- > > > > If you need further informations let me know. > > I tested other DVB-S2 transponders which have a QPSK modulation. All these > didn't want to lock and gave a timeout. DVB-S2 Transponders with a 8PSK > modulation did gave a lock (Hotbird has a couple, while I don't have > subscriptions to chose channels, I'm able to lock those). > > So my first impression was, it's a missing parameter in the Frontend > struct. So I made some changes and check if the transponder is DVB-S2 and > added parameters for DTV_PILOT (with data PILOT_AUTO) and when QPSK is > used with DVB-S2, to use the NBC_QPSK modulation (which is needed for > DVB-S2 if I'm not mistaken) instead of regular QPSK. > > However, didn't bring me the sollution I hoped for. I now have a timeout, > lost lock and regain lock, etc, etc, etc. But it's more then it was > before. > > So I'm close. Currently I do have a small problem where I put in > parameters which shouldn't been given (oops!) and now my DVB-card doesn't > lock any more, I need to reboot first. > > I hope to start to work on it this further when I'm done with work. I'll > keep you all posted :) > > BTW, I did manage to get DVB-T working. At least it locks on on the > encrypted channels, but I didn't had time to check for image. Mainly since > DVB-T is my backup for channel-viewing and I wanted to focus on the DVB-S2 > problem. > > > cu > > > > Edgar (gimli) Hucek > > Regards, > > Niels Wagenaar
May I ask you, Niels or Edgar, would you try szap-s2 with parameter -M3, which means NBC_QPSK modulation. It is interesting for me, whether it works. i'm not able to receive Astra HD+ and Anixe HD. Best Regards Igor M. Liplianin _______________________________________________ vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr