Just realized, what I was writing was actually mostly applicable to the SCA 80 pin drives.
On a 68 pin drive, there is usually a provision for on-board termination on the hard drive itself, unless it is a fairly modern U2W or newer SCSI drive. Anyway, if there is on-board termination on the drive, just put the drive on a cheap adapter, make sure it's at one end of the SCSI chain, and enable the on-board termination on teh drive and you should be good. You only need a drive with distinct upper byte termination if you're going to try to put the drive in the middle of the SCSI chain. My apologies for any confusion. It's been years since folks have regularly needed SCSI advice, so I'm a little rusty. -- -- ----- You received this message because you are a member of the Vintage Macs group. The list FAQ is at http://lowendmac.com/lists/vintagemacs.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml To post to this group, send email to [email protected] To leave this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/vintage-macs Support for older Macs: http://lowendmac.com/services/ --- You received this message because you are subscribed to the Google Groups "Vintage Macs" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
