Wayne, how did you patch these holes? I yanked the original a/c from my '66 Overlander and the roof looks like yours. I'm having Windish RV in CO install a new Penguin in the 14x14 over the kitchen, so have to patch these, currently with a temporary duct tape fix.Windish has to move my satallite dish, so I'm considering putting the sat over these holes. Any thoughts?
Randy Unter
'66 26' International Overlander

"Wayne A. Moore" wrote:

Bill,My 66 Trade Wind has only 3 Vents.The old split system AC unit that I removed was installed just aft of the second vent above the kitchen.Right through the roof . After I removed it there were 2 holes that needed to patched.  WAM52
'66 TWLY
'63 OLLY
'56 CARLY
WDCU 2000----- Original Message -----From: Bill Scott <[EMAIL PROTECTED]>To: <[EMAIL PROTECTED]>Sent: Sunday, June 04, 2000 5:22 PMSubject: Re: [VAC] a/c for a Trade Wind > John, your 65 Trade Wind should have 4 vent holes each one 14x14. The
> front and kitchen should have the standard type vents, unless they have
> been upgraded to Fantastic Fan Vents. The third vent just aft of the
> bulkhead separating  the kitchen from the bedroom, should be the hole
> for the A/C.  If it has a vent now, the vent should be removed, and a
> 110 volt romex wire should already be there for the A/C unit.   Your
> choices are limited.  You can put in a Coleman, or one of the new
> Carrier models, but really, there is only one choice.  The Duo Therm
> Penquin, is a solid performer, it is low profile, and it has a special
> condensate tray to catch and drain the condensate thru a special
> flexible hose that runs thru the cabinetry, and out thru a hole in the
> floor and bellypan.   If you use any other type of A/C, the condensate
> will snake around the roof for a while, until it finds an easy path to
> the ground.  If you can live with condensate dripping over the side,
> then get any A/C you wish.  Your local dealer can do the work, or even
> Camping World.
>
> Bill Scott
> 66 Trade Wind
>
>

Reply via email to