Bill,
I had to read it twice myself, but that was Mitch' point. When you want
to check the performance
of the oven, you want to measure something that has a decent bit of
variation over temperature.
Rob.
Op 29-6-2012 13:33, WB6BNQ schreef:
Mitch,
Quite the contrary. The 10 volt output is the master output and therefore the
most stable. The others are derived from dividers and thus add additional error
terms due to the tempco of the divider string and any possible loading presented
to those outputs.
Bill....WB6BNQ
Mitch Van Ochten wrote:
I think monitoring the 1V or 1.1V is a better test over temperature than
monitoring the 10V. It's quite stable even without the heater.
_______________________________________________
volt-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
