Any thing you do other than record the current voltage reading will introduce more uncertainty and increase drift unless you have a defect. Replacing a defective part will start the aging process over again for that part. Do not change anything if you can help it.
Agilent is a good cal lab to use as well. They will run it for a few days and take readings a few different times and give you a report. Most of the time the battery is not enough to keep the box hot until they plug it in so they count on warming up a few days. Hope that helps. John On Tue, Dec 31, 2013 at 3:31 PM, Chuck Harris <cfhar...@erols.com> wrote: > The obvious reason for that suggestion is the adjustment > pot is likely to be noisy and is likely to introduce > uncertainty. > > The big question that comes to my mind is if you care about > that level of uncertainty, why not replace the pot with a > voltage divider made of some low thermal coefficient fixed > value resistors? > > -Chuck Harris > > jeffh...@comcast.net wrote: > >> >> >> Hi, >> >> >> >> Are you guys adjusting your 732As? >> >> I have a friend that works in a large CAL lab and he told me to never >> adjust my >> 732As, just compare them. >> >> They send out their 732 Bs to Fluke but are never adjusted, just compared >> and sent >> back with current voltage reading ?? >> >> >> >> Thanks - Jeff >> > _______________________________________________ > volt-nuts mailing list -- volt-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/ > mailman/listinfo/volt-nuts > and follow the instructions there. > -- John Phillips _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.