I picked up a used HP3458A today, which I needed for some precision DC measurements i need to make. It passes all the self tests and the Auto Cal but is there any thing else I can check ( I have a 14 day RR). It reads a 10V standard I made within a few tens of ppm, but it's not a 732A but that is at least comforting. It also reads an ESI 10Kohm standard resistor dead on.
The only problem is that the display has some faint pixels in some locations, with three in the second row for every digit location dead. Likely a pixel driver I would think. I am not too familiar with it yet but I noticed when I push the auto zero button, the display has a blinking square until I hit a measurement mode button; e.g., DCV, ACV, OHM, etc. Is this normal? Regards, Randy Evans _______________________________________________ volt-nuts mailing list -- volt-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts and follow the instructions there.