I use a digital temperature controlled bath for my keeping my standard
resistors at 25C. It's versatile since it can do precision
temperature/time scans and can easily scan the range your interested in.
Right now I have it set to 25.00C with one of my ancient 10K ohm standards.
When I first bought my Leeds and Northrup resistors I wanted temperature
info on all of them to see if there was an especially good one. I was
scanning from 20C to 30C and writing down the resistance values at
every 0.1C point. Like Frank mentioned, I went through the temperature
range too fast and the data was useless do to hysteresis. Next time I
went much slower and the data was OK. My bath has a change in
temperature over time function so it will be much easier just to let the
3458A measure continuously and plot the output after the run. I can use
Labview to plot the data in real time if I get the urge to "program".
Use NPLC = 1000 and OHMSF for best results. Because of my old Leeds an
Nothrup reistors I have to use a DELAY of 10S. Most standards don't need
this but it's best to compare the resistors value at a Delay of 10S and
the default Delay. They should be identical.
I use the GPIB data port all the time and can't live without it.
Charlie
On 11/15/2014 1:48 PM, Richard Moore wrote:
Thanks for the replies — I have all I need except an environmental test chamber
to control temp. Of course, right now, I could stick the box outside and drop
its temp by 20C — but I really only need a range of 20C +/- 5C. But as it turns
out, I have a little portable insulated cooler/heater box for holding drinks
and food in the car that has a big reversible Peltier block in it, so maybe I
can finesse this temp testing…
_______________________________________________
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
_______________________________________________
volt-nuts mailing list -- volt-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
