I'm working on this issue for MFMP, with good progress. Best success so far is with Swagelok aluminum ferrules and stainless steel nuts, applied directly to the alumina tube. This combination is vacuum tight at 30 microns and pressure tight at 10 bar and nearly 800 C (at the center of the tube). My test report is here:
https://BRNO.uk.quickconnect.to/direct/ns/sharing/zctms

AlanG

On 1/15/2015 6:57 PM, Jack Cole wrote:

The description in the report is insufficient to determine what was used to make the seal and whether it was hermetically sealed.

On Jan 15, 2015 8:53 PM, "Axil Axil" <[email protected] <mailto:[email protected]>> wrote:

    It does work, It worked for Rossi for 32 days.

    On Thu, Jan 15, 2015 at 5:23 PM, Jack Cole <[email protected]
    <mailto:[email protected]>> wrote:

        It might work.  I have been looking at those options (i.e.,
        metal compression fitting).

        On Thu, Jan 15, 2015 at 4:02 PM, Axil Axil <[email protected]
        <mailto:[email protected]>> wrote:

            Like Rossi did, MFMP has just tested and intends to use in
            their next experiment  a metal plug or a thermocouple
            probe  to seal the fuel feed hole in the alumina rod.

            Why is this sealing process not right for you?

            On Thu, Jan 15, 2015 at 4:53 PM, Jack Cole
            <[email protected] <mailto:[email protected]>> wrote:

                Yes, it bolsters the results of the first experiment
                by demonstrating that reliability.

                On Thu, Jan 15, 2015 at 2:54 PM, Jed Rothwell
                <[email protected] <mailto:[email protected]>>
                wrote:

                    I wrote:

                        Well, it is a nice clean blank anyway. The two
                        sets of points fit on top of one-another
                        beautiful.


                    Meaning the instrument is reliable as a
                    calorimeter. This is important.

                    - Jed






Reply via email to