Axil, where did you see a description of the tiger? I do not recall any reference to the use of one module to drive the other 15.
Dave -----Original Message----- From: Axil Axil <janap...@gmail.com> To: vortex-l <vortex-l@eskimo.com> Sent: Tue, Dec 1, 2015 10:40 pm Subject: Re: [Vo]:LENR reactors need magnetic confinement It has be recently revealed that each 250kVA E-Cat tiger reactor module is composed of 16 reactors. Only one of those reactors is a powered activator(mouse). The other 15 are drones driven by the activator. The activator produces a reaction catalyst that drives the other drones. I say that the reaction catalyst is the magnetic Exotic Neutral Particle(ENP) that becomes mobile as its energy content level reaches a self sustaining threshold. At low temperatures the alumina tub reactor shell that all these reactors are comprised of confines the ENP. But as all these reactors heat up, the alumina shell becomes electrically conductive. At high temperatures, the alumina becomes magnetically transparent and this allows the ENP to leave the activator an enter the drone where the ENP catalyzes the LENR reaction. http://www.thevalvepage.com/valvetek/heater/fig1.gif Electrical conductivity Vs, temperature. On Tue, Dec 1, 2015 at 7:02 PM, Axil Axil <janap...@gmail.com> wrote: The so called Erzion phenomenon was discovered in a series of electrolytic experiments marked by unexplained changes in a pool of cooling water outside of the catalytic cell. After 40 minutes of electrolytic cell operation, water on the tungsten anode side of the cooling vessel started loosing its transparency. Water on the stainless steel cathode of the pool of cooling water remained transparent, at the same 40 C temperature. A sample of bubbly water, removed from the anode side, was tested for induced gamma radioactivity. No such radioactivity was found in it; the sample became transparent after 24 hours. Attempts to reproduce the long-term loss of cooling water transparency with other electrolytes, and under different electrical discharge conditions, were not successful. But the effect was highly reproducible when experimenting with the tungsten-anode electrolytic cell and the 7 M KF electrolyte containing 50% of heavy water. That cooling water on the outside of the electrolytic cell's glass reactor shell at the right side (see Figure 1) is close to the anode while cooling water on the left side is close to the cathode. The disappearance of bubbles, after the electrolysis, was very slow (half-life of about 10 hrs). Attempts to explain the phenomenon in terms of cavitation, and other ultrasonic effects, were not successful. The only satisfactory explanation was possible within the framework of the erzion model. Authors believe that bubbles are produced through the action of neutral Erzions. The Erzons phenomenon behavior is consistent with the magnetic based Exotic Neutral Particle(ENP). To begin with, the glass container is transparent to the magnetically based ENPs both optically and magnetically. The LENR reaction that keeps the ENPs viable produce the vapor that forms the water bubbles. The ENPs become energetically self sufficient in the water of the cooling pool where the ENPs remain viable for hours. If the Erzons phenomenon is produced by magnetically based ENPs, an iron plate placed just on the outside of the glass wall adjacent to the anode would prevent the ENPs from exiting the glass electrolytic cell. With the ENPs blocked from travel, bubble production would be eliminated. On Tue, Dec 1, 2015 at 5:37 PM, Axil Axil <janap...@gmail.com> wrote: In my opinion, the fundamental nature of the Rossi effect is based on magnetism. The catalytic particle that produces the reaction is magnetic in nature. This particle is produced by heat pumping and EMF stimulation. The nature of this Exotic Neutral Particle (ENP)is reflected by the behaviour of the E-Cat itself and reflect how the E-Cat operates. The ENP can exist at low energy pumping where the energy coming into the particle is equal to the energy leaving the particle. This is similar to the way Rossi keeps his reactor under control. Too much external energy pumping will result in the E-Cat going critical. The same process of over pumping happens with the ENP. Overpumping brings it to the stage where it becomes self-sufficient requiring no additional EMF input. The energized ENP can get EMF from the environment around it not requiring external heat or EMF simulation to be applied. The same is true for the E-Cat. When the E-Cat is subcritical, it requires heat and EMF stimulation to be applied. But when it is "over stimulated" it begins to meltdown since it has become independent from externally applied stimulation. The ENP can live as long as it can catalyze energy production from the material around it. The ENP can live for days on its own as it brings in energy from the environment to sustain its internal LENR reaction processes. Magnetic confinement increases efficiency of the reaction. Such confinement saves the externally applied energy that produced the ENP from being wasted. The ENP can leave the reactor if the material that makes up the reactor enclosure is transparent to the optical and magnetic nature of the ENP. This might be why electrolytic cells have difficulty in sustaining powerful LENR reactions. In this case, the ENPs escape the glass beaker reactor enclosure and all the input energy that was pumped into the ENP is wasted to the environment. outside the electrolytic cell. If the cell is made of material that can contain the ENP both optically and magnetically, the reactor will be efficent. Alumina is antiferromagnetic and will confine magnetic particles thy to escape the reactor shell. Another method of ENP confinement that Rossi might use is a solenoidal confinement coil that keeps the ENPs away from the reactor walls in the center axis of the reactor.