Hi Jed, Step 1 was sand paper. Step 2 and 3 were thorough cleaning with acetone, although I couldn't be certain of what was on there at a small scale.
Best regards, Jack On Thu, Jul 10, 2014 at 1:46 PM, Jed Rothwell <jedrothw...@gmail.com> wrote: > Jack Cole <jcol...@gmail.com> wrote: > > Axil, >> >> I tried fine grit sand paper and acid. >> > > I think that will contaminate the material. You better clean it repeatedly > and carefully after that. > > I will grant, Mizuno and Ohmori used to scratch the surface of their > glow-discharge cathodes with glass. The cathodes ended up looking like this: > > http://lenr-canr.org/wordpress/wp-content/uploads/2012/02/Image09.jpg > > I would say that is contaminated. I would not use it for electrolysis. > > This is from: > > http://lenr-canr.org/?page_id=187#PhotosTMizuno > > > Mizuno's recent experiments with glow discharge produce a rough surface in > situ with very little contamination, as explained in the ICCF18 paper: > > http://lenr-canr.org/acrobat/MizunoTmethodofco.pdf > > - Jed > >