I have a netbook running Win7 Starter Edition and I'm trying to establish an
IPSec tunnel with my Linksys RV042. I've used all the same settings from here:
http://www.shrew.net/support/wiki/HowtoLinksys
Using v2.1.6 I could not establish a tunnel. The "Network" tab in the Shrew
client said 'Established - 0' and my router log only showed the tunnel getting
to phase 1 and then it would stall. I've upgraded to v2.1.7 beta and now it
appears I can create the tunnel (Shrew client says 'Established - 1', router
log shows tunnel successfully created, and the tunnel and client show up in the
router's active VPN list. However, I cannot ping or access any addresses
through the VPN.
If I try to ping any addresses through the tunnel and use Wireshark to monitor
the tunnel interface, it shows standard arp "who has" requests but the response
is always the same. Also, after the arp request there aren't any ICMP packets.
Here's what's shown in my arp cache:
C:\>arp -a
Interface: 192.168.x.1 --- 0x10
Internet Address Physical Address Type
192.168.y.1 bb-bb-bb-bb-bb-00 dynamic
192.168.y.10 bb-bb-bb-bb-bb-00 dynamic
192.168.y.100 bb-bb-bb-bb-bb-00 dynamic
.
.
Is this behavior correct or is something not setup correctly?
Thanks,
Matt
_______________________________________________
vpn-help mailing list
[email protected]
http://lists.shrew.net/mailman/listinfo/vpn-help
