On 9/6/2010 7:11 PM, Matt Johnson wrote:
I have a netbook running Win7 Starter Edition and I'm trying to
establish an IPSec tunnel with my Linksys RV042. I've used all the
same settings from here:
http://www.shrew.net/support/wiki/HowtoLinksys
Using v2.1.6 I could not establish a tunnel. The "Network" tab in the
Shrew client said 'Established - 0' and my router log only showed the
tunnel getting to phase 1 and then it would stall. I've upgraded to
v2.1.7 beta and now it appears I can create the tunnel (Shrew client
says 'Established - 1', router log shows tunnel successfully created,
and the tunnel and client show up in the router's active VPN list.
However, I cannot ping or access any addresses through the VPN.
If I try to ping any addresses through the tunnel and use Wireshark
to monitor the tunnel interface, it shows standard arp "who has"
requests but the response is always the same. Also, after the arp
request there aren't any ICMP packets. Here's what's shown in my arp
cache: C:\>arp -a Interface: 192.168.x.1 --- 0x10 Internet Address
Physical Address Type 192.168.y.1 bb-bb-bb-bb-bb-00
dynamic 192.168.y.10 bb-bb-bb-bb-bb-00 dynamic
192.168.y.100 bb-bb-bb-bb-bb-00 dynamic . .
Is this behavior correct or is something not setup correctly?
What does your debug log output look like?
http://www.shrew.net/support/wiki/BugReportVpnWindows
-Matthew
_______________________________________________
vpn-help mailing list
[email protected]
http://lists.shrew.net/mailman/listinfo/vpn-help
