Hi guys, there was a mistake in my client configuration, the addressing method was set "use an existing adapter ...". After setting it to "Use a virtual adapter ..." everything worked fine.
Many thanks, Thorsten -----Ursprüngliche Nachricht----- Von: [email protected] [mailto:[email protected]] Im Auftrag von kevin vpn Gesendet: Samstag, 5. März 2011 05:11 An: [email protected] Betreff: Re: [vpn-help] Problems using shrew to connect to ns5gt On Sun, 27 Feb 2011 15:50:11 +0100 "Thorsten Steffen" <[email protected]> wrote: > Hi guys, > > I'm trying to connect to Juniper NS5GT (Hardware Version: 1010, > Firmware Version:6.2.0r2.0 Firewall+VPN) with Shrew VPN Client 2.1.7 > (running on Win7 64bit) without success. > > I used http://www.shrew.net/support/wiki/HowtoJuniperSsg to configure > both sides. > ... > > I think "xauth login FAILED. gw <vpnclient_gateway>, username > <thorsten>, retry: 0, timeout: 1" is the relevant message. > > Hi Thorsten, You're right that the Juniper logs suggest that the problem is at the XAuth authentication step. I'd double-check the steps you performed when configuring the user on the SSG device (section "Create Local User Accounts" in the HowTo). Most especially, check the password you entered. _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
