Last time I needed something like that I found it was cheaper to get 5 dual fan disk caddies ( 5 being a delivery charge waived quantity) than to get 1 'spare part' fan
Then simply had to use a screwdriver to undo 2 screws, and sell on 4 caddy units JimB ----- Original Message ----- From: "Joseph Harrison" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Tuesday, July 11, 2006 12:17 PM Subject: Re: Asus A7M266MB > Hello > > I pulled the ram and found that it had become unseated, after 5 + years. > The heat sinks for passive ram cooling had drifted down and unseated 1 end > of the chip, even though held in place by a heat transfer glue strip and 2 > spring clips. Removed the heat sinks and glue, took over an hour to be > sure not to damage the ram in case it was still good. > > Vacuumed out the dust, as I do every 3 to 4 months and cleaned the ram > and the ram slot with contact cleaning solution and reinstalled it and it > worked as new showing 512MB and no problems. > But still can't run for long because the cooling fan on the > AMD761 System Controller is dead, this is one of those small fans > about 2 inches across and has 3 wires, anyone know where I can > order one of these? > > Also this is all I can find on the ram module, is this enough to tell > if it is a high density stick or a low density? > > DIMM1: Xerox (512 MB PC2100 DDR SDRAM) > Memory Module Properties: > Module Name Xerox > Module Size 512 MB (2 ranks, 4 banks) 16 chips on 2 sides > Module Type Unbuffered > Memory Type DDR SDRAM > Memory Speed PC2100 (133 MHz) > Module Width 64 bit > Module Voltage SSTL 2.5 > Error Detection Method None > Refresh Rate Normal (15.625 us), Self-Refresh > Memory Timings: > @ 133 MHz 2.5-3-3-6 (CL-RCD-RP-RAS) > @ 100 MHz 2.0-2-2-5 (CL-RCD-RP-RAS) > Memory Module Features: > Early RAS# Precharge Not Supported > Auto-Precharge Not Supported > Precharge All Not Supported > Write1/Read Burst Not Supported > Buffered Address/Control Inputs Not Supported > Registered Address/Control Inputs Not Supported > On-Card PLL (Clock) Not Supported > Buffered DQMB Inputs Not Supported > Registered DQMB Inputs Not Supported > Differential Clock Input Supported > Redundant Row Address Not Supported > > Thank You Joe Harrison > > -- > ---------------------------------------- > WIN-HOME Archives: http://PEACH.EASE.LSOFT.COM/archives/WIN-HOME.html > Contact the List Owner about anything: [EMAIL PROTECTED] > Official Win-Home List Members Profiles Page > http://www.besteffort.com/winhome/Profiles.html > > > -- ---------------------------------------- WIN-HOME Archives: http://PEACH.EASE.LSOFT.COM/archives/WIN-HOME.html Contact the List Owner about anything: [EMAIL PROTECTED] Official Win-Home List Members Profiles Page http://www.besteffort.com/winhome/Profiles.html
