Try one of these to replace that fan: http://www.nexfan.com/40mmfans1.html
[Shipping is flat rate $7 for however much you buy there, so look around and ask your friends if they also need something. Use coupon code "cooldown" at checkout for 10% discount on merchandise (expires 7/14).] As for the RAM stick you have, 2 ranks suggests low density. Carl -----Original Message----- From: Windows Home/SOHO [mailto:[EMAIL PROTECTED] On Behalf Of Joseph Harrison Sent: Tuesday, July 11, 2006 7:18 AM To: [email protected] Subject: Re: Asus A7M266MB Hello I pulled the ram and found that it had become unseated, after 5 + years. The heat sinks for passive ram cooling had drifted down and unseated 1 end of the chip, even though held in place by a heat transfer glue strip and 2 spring clips. Removed the heat sinks and glue, took over an hour to be sure not to damage the ram in case it was still good. Vacuumed out the dust, as I do every 3 to 4 months and cleaned the ram and the ram slot with contact cleaning solution and reinstalled it and it worked as new showing 512MB and no problems. But still can't run for long because the cooling fan on the AMD761 System Controller is dead, this is one of those small fans about 2 inches across and has 3 wires, anyone know where I can order one of these? Also this is all I can find on the ram module, is this enough to tell if it is a high density stick or a low density? DIMM1: Xerox (512 MB PC2100 DDR SDRAM) Memory Module Properties: Module Name Xerox Module Size 512 MB (2 ranks, 4 banks) 16 chips on 2 sides Module Type Unbuffered Memory Type DDR SDRAM Memory Speed PC2100 (133 MHz) Module Width 64 bit Module Voltage SSTL 2.5 Error Detection Method None Refresh Rate Normal (15.625 us), Self-Refresh Memory Timings: @ 133 MHz 2.5-3-3-6 (CL-RCD-RP-RAS) @ 100 MHz 2.0-2-2-5 (CL-RCD-RP-RAS) Memory Module Features: Early RAS# Precharge Not Supported Auto-Precharge Not Supported Precharge All Not Supported Write1/Read Burst Not Supported Buffered Address/Control Inputs Not Supported Registered Address/Control Inputs Not Supported On-Card PLL (Clock) Not Supported Buffered DQMB Inputs Not Supported Registered DQMB Inputs Not Supported Differential Clock Input Supported Redundant Row Address Not Supported Thank You Joe Harrison -- ---------------------------------------- WIN-HOME Archives: http://PEACH.EASE.LSOFT.COM/archives/WIN-HOME.html Contact the List Owner about anything: [EMAIL PROTECTED] Official Win-Home List Members Profiles Page http://www.besteffort.com/winhome/Profiles.html -- ---------------------------------------- WIN-HOME Archives: http://PEACH.EASE.LSOFT.COM/archives/WIN-HOME.html Contact the List Owner about anything: [EMAIL PROTECTED] Official Win-Home List Members Profiles Page http://www.besteffort.com/winhome/Profiles.html
