I have a configuration question regarding the 3800 AP series. I am wanting to use both Ethernet connections on the AP, when I put both switch ports in a port channel, have the port active, the ap leaves the controller. If I shut switch port for the APs eth1, the ap joins the controller. We are using Cisco C2960x running 15.0(2a)EX5. Any thoughts suggestions on the switch config to utilize the ap’s eth1.
Thanks Roger University of Tennessee Health Science Center From: "WIRELESS-LAN@LISTSERV.EDUCAUSE.EDU" <WIRELESS-LAN@LISTSERV.EDUCAUSE.EDU> on behalf of "Jeffrey D. Sessler" <j...@scrippscollege.edu> Reply-To: "WIRELESS-LAN@LISTSERV.EDUCAUSE.EDU" <WIRELESS-LAN@LISTSERV.EDUCAUSE.EDU> Date: Wednesday, December 21, 2016 at 6:07 PM To: "WIRELESS-LAN@LISTSERV.EDUCAUSE.EDU" <WIRELESS-LAN@LISTSERV.EDUCAUSE.EDU> Subject: [WIRELESS-LAN] Prime 3.1.4 - 2800/3800 - Maps - b/g clients always show zero Would someone do a sanity check for me. Prime 3.1.4 (with or without device pack 6) with 2800/3800-series WAPs. When drilling down into a building, the b/g/n clients are properly reported at the building view level. If one drills down to the floor view, all 2.4Ghz (XOR) radios show zero (0) clients. I’m sure it’s was like this in 3.0 and 3.1 too. I’ve opened a TAC case, and I’ve been told I’m first to report it (no bug open). If you happen to have Prime and the new 2800/3800’s I’d appreciate a double-check. Hopefully it’s not unique to me. Best, jeff ********** Participation and subscription information for this EDUCAUSE Constituent Group discussion list can be found at http://www.educause.edu/groups/. ********** Participation and subscription information for this EDUCAUSE Constituent Group discussion list can be found at http://www.educause.edu/groups/.