Don't forget pigtails. I have had a simple Pigtail cause odd receive signals at the AP end.
Steve Barnes Executive Manager PCS-WIN RCWiFi Wireless Internet Service (765)584-2288 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mark McElvy Sent: Tuesday, May 20, 2008 4:07 PM To: WISPA General List Subject: Re: [WISPA] Lightning Surge Suppressers Well the reason for concern is about a month ago I lost a 3 sector tower to lightning or at least during a lightning storm. Everything with an Ethernet port lost the Ethernet port as well as the three radios. I replaced all three aps but left the lightning suppressors in place. One of the AP's seems to have poor receive signals. I am trying to determine if it is the new foliage or a blown suppressor. Mark McElvy AccuBak Data Systems, Inc. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jack Unger Sent: Tuesday, May 20, 2008 2:34 PM To: WISPA General List Subject: Re: [WISPA] Lightning Surge Suppressers Mark, I doubt the ohmeter will tell you anything. The gas tube is supposed to measure "open". It's job is to conduct only when lightning needs to be shorted to ground instead of going through your equipment. Put the arrestor inline between an antenna and a radio. If the radio works as well after installation as it did before then the arrestor is "probably" OK, assuming the gas tube isn't bad. After a lightning storm, if your radio stills works as well as it did before the storm then you know the gas tube is probably good. If you think the gas tube is probably bad then just replace it with a new one. jack Mark McElvy wrote: > I have some Altelicon glass tube lightning surge arresters. I am trying > to figure out how to test then to see if they are good. I have used an > ohm meter to compare a new one with an old one I suspected to be bad but > all reads the same. The replaceable glass tube measures open on bothe > old and new. > > > > Mark McElvy > AccuBak Data Systems, Inc. > > > > > > > > ------------------------------------------------------------------------ -------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > ------------------------------------------------------------------------ -------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > -- Jack Unger - President, Ask-Wi.Com, Inc. Serving the Broadband Wireless Industry Since 1993 Cisco Press Author - "Deploying License-Free Wireless WANs" Vendor-Neutral Wireless Design-Training-Troubleshooting-Consulting FCC License # PG-12-25133 Profile <http://www.linkedin.com/in/jackunger> Phone 818-227-4220 Email <[EMAIL PROTECTED]> ------------------------------------------------------------------------ -------- WISPA Wants You! Join today! http://signup.wispa.org/ ------------------------------------------------------------------------ -------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ ---------------------------------------------------------------------------- ---- WISPA Wants You! Join today! http://signup.wispa.org/ ---------------------------------------------------------------------------- ---- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
