It's on the Interface, under IP addresses. Change the bridge group number from 0 to something else. All interfaces with the same number (other than Zero) will be bridged.
Mark Nash UnwiredWest 78 Centennial Loop Suite E Eugene, OR 97401 541-998-5555 541-998-5599 fax http://www.unwiredwest.com ----- Original Message ----- From: "Marlon K. Schafer" <[EMAIL PROTECTED]> To: "WISPA General List" <wireless@wispa.org> Sent: Tuesday, June 10, 2008 4:33 PM Subject: [WISPA] star os config help > Hi All, > > I have a 4000 ap. I'll only be using one radio card and the ethernet. > > I can't figure out how to turn it into a bridge ap. Can anyone tell me > where to look? > > The only thing I've found so far talks about bridging is spanning tree > (not > helpful) and some kind of rf to rf bridge thingy. Also not helpful. > > Can anyone take the time to walk me through the setup on this box? Kindly > send your phone number (off list) and I'll call you around 8 or 8:30 am > tomorrow (wed). > > Thanks!!! > marlon > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/