Could test by setting up a pair of single pole dishes, align one, misalign the other.
----- Mike Hammett Intelligent Computing Solutions http://www.ics-il.com On 6/12/2010 12:08 PM, Travis Johnson wrote: > Hi, > > I would still like to know what it's going to do when an entire > polarization gets jammed with noise? Will the radio still pass traffic? > Or will there be so many errors that it will overtake the link and > nothing will work? > > Travis > Microserv > > Tom DeReggi wrote: > >> I jsut wanted to mention, that it really does give peice of mind knowing >> that there is a MIMO technology out there that I can count on, that is >> inexpensive. >> I just finished my 4th Ubiquiti PTP link (over last two weeks). Once again, >> Painless and perfect. >> I got 38mb one way 22mb the other with 10Mhz Channel MCS 15. And with 20Mhz >> channel up to 69mbps one way, and 80 the other. >> Link Quality nad Capacity showed like 96%. LAtency was also down under 2ms. >> But my point here is not the speed. It was that it was easy. I just put it >> up, and it worked. Air view was helpful, finding channel. All 4 installs >> worked that way. No hassle, no fuss. >> This last one was a 15 mile link, Rocket5M on each side, with PACWireless >> 2ft dish on one end and a 23 db panel on the other. >> Nothing has ever been this easy. >> >> With that said.... There were some confusing things. I ran V on Chain0, and >> H on Chain1 got -66, then for grins swapped conectors on CPE side only, so >> Chain0 was H and Chain1 was V and got -65. >> I do not understand why this happened. I would have thought signal should >> have dropped by -20 db or so? Wierd. This did not just happen when in >> Alignment mode. I may have been in MCS7 mode at the time though. >> So it appears it must be transmitting on both pols in MCS7 mode, I dont have >> any other way to explain it. But none the less, it just worked. >> >> I'm concern about using it at PtMP, because we use Station WDS, and AP only >> supports up to 6 WDS clients. So it wont scale for PTMP Briding clients. >> Unless that can be curred. But I tell you for PTP, or a couple associations, >> its pretty sweet. >> >> (I still like T-Link-45s better when I only need 25-30mbps, but the UBNT >> has shown to be a wonderful experience, also.) >> >> >> Tom DeReggi >> RapidDSL& Wireless, Inc >> IntAirNet- Fixed Wireless Broadband >> >> >> >> -------------------------------------------------------------------------------- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> -------------------------------------------------------------------------------- >> >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> >> >> > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/