It works perfectly fine if you power through the secondary port. On Fri, Sep 24, 2010 at 8:05 PM, RickG <rgunder...@gmail.com> wrote: > I was skeptical of the poe passthrough sicne I first saw it and this is why. > On repeaters, it would be so tempting to just run one wire but I've stuck > with two. It will be interesting to see if it gets fixed. Thanks for > sharing! > > On Fri, Sep 24, 2010 at 8:50 PM, Robert West <robert.w...@just-micro.com> > wrote: >> >> Today I finally figured out an Issue I’ve been having with a >> NanoStation5M. I have a customer who wanted service, was in trees but had >> a hot signal out at the road. Dug a 4 foot hole, put in 2 10 foot sections >> of rigid conduit and 5 bags of concrete. Ran an underground line of Cat5e, >> double shielded and flooded cable with ground wire to his house. That was 5 >> months or so ago. At the beginning of August, he called me and said his >> neighbor wanted service. Same trees so I took the AirGrid down, put up a >> Nano5M and plugged a Nano loco2 into the secondary port and shot it at a >> second Nano Loco2 at his place. Replaced my weird Airgrid >> >> >> >> Worked perfectly, everyone happy. 2 weeks ago I get a call, neighbor not >> working. I go out, no power light on the Nano at the pole. I figure, bad >> crimp……. Take it down, make up a new wire to connect the two, fires up. >> All good. 2 days later, same issue. I reset it all to defaults, >> reconfigure, all okay. 2 days later, same thing. I downgrade firmware to >> 5.2. Couple of days later, no signal again. I’ll also add I was getting >> some “weird” lag at the AP that this setup was feeding off of. So I was >> fighting two battles. Then today, I find that the PoE Pass Through check >> box is empty. DUH! I check it, apply, comes back empty. I do it again, >> same issue. I go out and I can connect my laptop through the secondary port >> but it will not give any voltage. >> >> >> >> I checked my lag time issue at the AP. GONE! >> >> >> >> I then checked in the UBNT forums…………. It’s an issue. After 20 days PoE >> on the secondary Nano port starts to die. Replaced it with another Nano5M, >> working fine but looks like I’ll be coming up with another MacGyver solution >> to service this dude………. >> >> >> >> Just so ya knows. >> >> >> >> Bob- >> >> >> >> >> >> >> >> >> >> >> >> -------------------------------------------------------------------------------- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> >> -------------------------------------------------------------------------------- >> >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ >
-------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
