Hi Charlie,
My apologies -- the change in r5491 was a bad idea and caused the
Doppler corrections to fail. I have backed out that change. Please
upgrade to r5493 and rebuild. It should be OK now (but the FT-817 issue
remains unresolved).
-- Joe, K1JT
On 6/2/2015 8:55 AM, [email protected] wrote:
> I think I have found some unexpected Doppler control behaviour in r5491.
> This has not yet been verified by other testers, so please treat as
> preliminary feedback.
>
> What I see is:
>
> With Monitor on and Enable TX not red, all modes of Doppler control do not
> function on RX (as was the case with r5318).
>
> With Enable TX activated during a rx period, Doppler works on rx
> immediately, and also on tx when tx period starts.
>
> If Halt TX is pressed midway through a tx period the rig and dial freq
> stays on tx freq until the end of the tx period, then dial freq turns red
> at about t=52s.
> Dial freq turns to normal colour if you touch the rig's tuning.
>
> Tune engages Doppler OK and behaviour is normal.
>
> If you tune or come to the end of a test, rx stays where it last was
> from Doppler correction and the only way to get it back to nominal
> sked frequency is to toggle enable Tx.
>
> Occasionally on program start dial frequency is red and rig does not seem
> to get commands, requiring a TEST CAT before it works. I have not found a
> way of reproducing this however.
>
> Charlie
>
>
> ------------------------------------------------------------------------------
> _______________________________________________
> wsjt-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
