I am using FT8 with WSJT-X without CAT control (only PTT is controlled via
a serial interface). In order to change the band (and not to report faulty
results to PSKReporter), I have to do the following:
1. Disable transmit and monitor
2. Change the band on my transmitter (and tune the antenna) the
3. Enable monitor mode and right away
4. Change the band in WSJT-X
It would be much safer to change the band in WSJT-X between steps 1 and 2
because when I then perform #3, WSJT-X would already be configured for the
correct band.
When I perform the steps in the sequence #1, #4, #2, #3, the band selection
performed in step #4 will be reverted to whatever was selected before I
disabled monitor mode.
This is with version 1.9.0rc3 on a Mac, but has worked the same way with
all previous versions I've used.
Thanks and 73,
Karl Heinz - K5KHK
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
