I discovered something interesting about the FT-747GX, and I'm not sure if it belongs here or in a hamlib devel group, but I'll give this a shot.
Each time I set a new band, TX, or send any other command from wsjt-x to the rig, it jumps 10 Hz. I believe this is due to settings for the byte interval and command interval, or perhaps a lack thereof. I tinkered around with those settings and discovered the same thing happens in fldigi and flrig. However, when I set the byte interval to 15 ms and the command interval to 50 ms, this stops happening. The rig stays dead on frequency, regardless of commands issued. >From some reading I've done online, the default byte interval in hamlib is >zero, so it makes sense that an older, slower rig might suffer some confusion. > I have attached the flrig settings I used to cure this issue. Note that this >byte interval is outside what the FT-747GX manual recommends. I have >discovered through additional reading that this is quite obviously wrong in >the manual. Any attempt to set the byte interval above 20 ms results in a >locked up radio, and locked up control program. L. Shane Stroud AE5SS
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
