I just experienced this behavior playing around tonight, I noticed I got stuck in message 2 during a qso and when I hit "Halt TX" it switched off my transmitter but did not clear EnableTX button. Then a few moments later my transmitter keyed as it began the next scheduled TX cycle.
I just tried to reproduce (Linux) and I can reproduce it starting up the application, enable TX, let it start calling CQ and part way thru hit Halt TX while it is transmitting. The transmitter shuts down but it resumes the next scheduled slot. Also I notice if its not transmitting but is during a "slot" when it should be, if I press halt my transmitter seems to quickly key up then un-key immediately. If I press Halt TX during a slot when I am not supposed to be transmitting, nothing happens. I'm using an ICOM 7100 with CAT control if that makes any difference for the PTT selection. -Matt / KK4NDE -----Original Message----- From: Bill Somerville [mailto:g4...@classdesign.com] Sent: Tuesday, April 30, 2019 12:00 PM To: wsjt-devel@lists.sourceforge.net Subject: Re: [wsjt-devel] Halt Tx Button On 30/04/2019 02:10, Neil Zampella wrote: > Hi all, > > trying to stop a Tx by clicking the Halt Tx button, it stopped the > rig, but did NOT reset the Enable Tx, and actually caused a couple of > entries in the RxFrequency window when I clicked it twice. > > Tested it under FT8 mode, and it works normally there. V2.1.0-RC5 64 bit. > > Neil, KN3ILZ Hi Neil, thanks for the issue report. I am unable to reproduce this, if you can come up with a recipe for reproduction that would be most helpful. 73 Bill G4WJS. _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
