Thanks Joe. I am on 6m with a local ISCAT group so you’re right I should have checked the VHF/UHF box. I will do that now!
73, Kevin Sent from my iPhone > On May 26, 2020, at 08:41, Joe Taylor <[email protected]> wrote: > > Hi Kevin, > >> On 5/26/2020 9:27 AM, Kevin McQuiggin VE7ZD/KN7Q wrote: >> >> I note that if you quit RC2 while in ISCAT B mode, that when you restart the >> application the indicated mode on the bottom status bar is “ISCAT B”, but >> that the spinner control on the window is set to “Submode A". See the >> screen shot: > > ... > >> While this may just be a UI initialization issue, it is an operational and >> visual distraction, so the spinner should probably be set to match the saved >> submode. Support for operator situational awareness should have the two >> indicators match. > > Thanks for pointing out this anomaly. It will be corrected in the next > release. > > Evidently you are operating with "Enable VHF/UHF/Microwave features" > unchecked. As a general policy, WSJT-X recommends using submodes (such as > JT65B, ISCAT B, etc.) only on VHF bands and higher. Unless you have some > specific reason I don't know about, you should check that box when using > ISCAT. > > And then, you would never have noticed the anomaly you reported -- hi. > > -- 73, Joe, K1JT > > > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
