There is no effect setting poll rate 1s, 2s or 5s. Always fails after a
while. I would say that shorter poll rate seems to raise problems faster.
I think I clean up everything and recompile all again.
--
Saku
OH1KH
Saku via wsjt-devel kirjoitti 30.8.2021 klo 17.27:
Black Michael via wsjt-devel kirjoitti 27.8.2021 klo 18.22:
Those cache times are showing 10134ms = 10 seconds since the last time
ptt was polled. For FT4 that's not good.
What is your polling rate in WSJT-X?
Mike W9MDB
Hi MIke!
Poll rate is 5sec. Compared to FT4 period it is too long, but I expect
that every needed command is placed at time it should happen (not placed
in poll queue) and reply for sent command comes immediately and at all
other times (when not any special job to execute) rig is polled by poll
rate.
But if every rig cat command sent and responded go via poll queue then I
just wonder how it has worked this far from the beginning of FT4 mode.
I'll try next to minimize the poll rate and see what happens.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel