Curt.. Tnx fer ur quick note. Always fun to here from another ham who share the same passions😁 I soloed a c-150 in 1961 and got my private in ‘64 in HS. Got my Airframe license in ‘66 from Teterboro School of Aeronautics and wound up in the AF b4 I could finish my engine license. Retired from America West as an Airbus Capt in 2006. I’ve had a chance to fly a Cub several times and enjoyed it very much. Leadville was always a treat! I had the RV up there several times for Bfast with another RVer but alway had to leave by 10A b4 the the DA got too high. I run WSJT-X along with gridtracker , an IC 7610 and a DX Commander ABV at home. When I do POTA I use an FT 891 into a half wave vertical on a drive on mount with a Spider pole. Works pretty well as I can set the whole station up in the SantaFe as the rear passenger seat as the op position. Some parks I have to activate w/o internet so I have to use a GPS dongal for time sync using Meinberg. The RV was fun to build. I just wish it didn’t take 12 1/2 years to build as I had to commute to PHX to work. I’m not familiar with the VAC software but I’ll look it up. Hope this finds you and your family well and safe. Happy holidays and hope to see you down the log… 73 😁
Fred Hollendorfer, W0SP Wheat Ridge, CO > On Nov 1, 2021, at 07:50, Bill Somerville via wsjt-devel > <wsjt-devel@lists.sourceforge.net> wrote: > On 01/11/2021 12:22, Dave Fitches via wsjt-devel wrote: >> I recently got another RTL-SDR to hook up to my system. (Win 10) >> >> I was planning to run one using WSJT-X running FT8, the other another >> running WSPR >> >> However... it seems that WSJT-X will only recognise ONE Virtual Audio Cable >> (VAC)... >> >> I recently set up two additional VAC's (for a total of three) and they work >> perfectly - unless I'm using WSXT-X which will only recognise ONE on the >> Soundcard Input feed, though it DOES show all THREE VAC's on the OUTBOUND >> sound card selection... >> >> Similarly (and no surprise because it's using the same code) JS8Call has the >> same issues. >> >> I'm using the VAC software from V.Burel / JS-Loezic - >> https://vb-audio.com/Cable/ >> >> -- >> >> >> = Dave Fitches = > > Hi Dave, > > no one else has reported a similar issue. I have VAC installed (not VB-Cable > but similar) with 8 devices and that all show up in both WSJT-X audio input > and out devices as expected. do other applications that use audio devices via > the MME audio sub-subsystem like Audacity show them? > > > 73 > Bill > G4WJS. > > > > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
