Hi At the moment I think that modes 2 and 15 are ambiguous in the WSPRNET database. There does not seem to be an up-to date formal definition for uploads (direct or bulk) to the WSPRNET Database at present - at least none that I have found. This is a bit annoying at times. This would be an oportunity for someone who understands the database to publish a short specification. The interactive WSPRNET database works very well except for the "mode" selection.
Regards David Owen GM1OXB On Tue, Nov 22, 2022 at 6:26 PM Stefan HB9TMC via wsjt-devel <wsjt-devel@lists.sourceforge.net> wrote: > > Hi, > > When WSPR and FST4W spots are uploaded to wsprnet, there is an > additional field to designate the mode. > > From wsjtx/Network/wsprnet.ccp lines 274 to 288 > it was intended to use different mode IDs for WSPR and FST4W in order to > distinguish between the two modes in the wsprnet database. > > WSPR-2: "2" > WSPR-15: "15" > FST4W-120: "3" > FST4W-300: "5" > FST4W-900: "16" > FST4W-1800: "30" > > However, wsprnet does only accept the mode IDs 2, 5, 15 and 30. All > other numbers are rewritten in their database to "2". > > FST4W-120 becomes "2" instead of "3" > FST4W-900 becomes "2" instead of "16" > > So it still kind of works for all modes, except FST4W-900, which is > stored as mode "2". > > > There are two possible ways to fix this. Either wsprnet would accept the > other mode IDs. Or it is fixed in WSJT-X. > > I tried to reach someone from wsrpnet, but without success. > So, unless someone knows someone from wsrpnet who could fix it there, I > would ask you to fix it in WSJT-X, by uploading FST4W-900 as mode "15". > > > Thanks, 73 > Stefan > > > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
