on 3/2/2007 11:32 AM Robert Grattan said the following:
For some reason unknown to me, Xastir cannot open my ttyS0 port which connects
a KPC 9612+ (V 8.2). The system has been running fine for several years with
exactly the same hardware setup and I do not recall any changes to anything
except the usual RedHat and Xastir patches/upgrades. I took the KPC 9612+ out
of and back into KISS mode and it seems to be receiving ok. As best I can
tell, the COM 1 port is working ok. The Xastir program runs fine but it can't
open ttyS0 and gives the Hard Fail error.
If anyone has any suggestions about how I might figure this out then I would
greatly appreciate it. Thanks.
Sounds like a permissions issue? Make sure the user running xastir has r/w
access to the serial devices.
-Lance KJ5O
Bob N4MRV
Ashland, VA
I am presently running Xastir 1.8.5 on RedHat 4 (2.6.9-42.0.10.EL)
Linux 2.6.9-42.0.10.EL #1 Fri Feb 16 17:06:10 EST 2007 i686 athlon i386
GNU/Linux
configure:3482: result: found /dev/ttyS0 and /dev/ttyS1
_______________________________________________
Xastir mailing list
Xastir@xastir.org
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
--
J. Lance Cotton, KJ5O
[EMAIL PROTECTED]
http://kj5o.lightningflash.net
Three Step Plan: 1. Take over the world. 2. Get a lot of cookies. 3. Eat the
cookies.
_______________________________________________
Xastir mailing list
Xastir@xastir.org
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir