Hi Rob, Have you taken a look at the built-in help topic called "Configure Serial KISS TNC"? It mentions that the default configured digipeating paths include your call and WIDE1-1. If that's not what's being used locally, it tells you what item in the xastir.cnf file to hand-edit, and to make you do so while xastir isn't running.
Hope that helps! Also, you didn't mention what firmware you're using in your TNC2 - some of them had bugs - I think v1.0.8 was the one that notably failed to obey having full-duplex disabled. 73, Bob, KD7NM -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rob Compton Sent: Wednesday, September 17, 2008 10:21 AM To: xastir@xastir.org Subject: [Xastir] Digipeating question. Hi all, I have a system running under Gentoo with a fairly current kernel (2.6.22) The TNC is a TNC2 running in KISS mode, and is controlled directly from xastir. It's running as an iGate, and happily ports data from RF to Inet, no problem. It also ports data from Inet to RF. But it doesn't digipeat RF, even though the box is selected in the port settings. Any ideas on why I'm missing? Regards Rob M0ZPU MB7UZP - Bedfordshire APRS iGate - IO92VC - 144.800MHz _______________________________________________ Xastir mailing list Xastir@xastir.org http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir _______________________________________________ Xastir mailing list Xastir@xastir.org http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir