You can change the value of 'netboot' to 'xnba' from 'pxe' if you were using the 'pxe' and try again. The change of 'default xCAT' in the configuration file can be done in the pxe.pm or xnba.pm depends on which method you were used in 'netboot'.
Thanks Best Regards ---------------------------------------------------------------------- Wang Xiaopeng (王晓朋) IBM China System Technology Laboratory Tel: 86-10-82453455 Email: [email protected] Address: 28,ZhongGuanCun Software Park,No.8 Dong Bei Wang West Road, Haidian District Beijing P.R.China 100193 From: "heince.nvg" <[email protected]> To: [email protected] Date: 2011-11-15 21:30 Subject: [xcat-user] node can't boot after installation Hi, I use 2.6.8 CentOS 6.0 on IBM x3755 & x3850 x5. After installation finished, node can't boot to disk. I have to change 'default xCAT' to 'default chain.c32' on the node tftpboot config file then it can boot. so, i need to modify tftp config on mn for each node after postscripts is finished. where can i add this line on xCAT ? Thanks, Heince ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ xCAT-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/xcat-user
<<inline: graycol.gif>>
------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1
_______________________________________________ xCAT-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/xcat-user
