It's been quite a few years since I last touched xCAT so hello again from 
me!

rnetboot is failing to install my compute nodes, they are IBM Power 8 S822 
boxes.  The command appears to power the box successfully to the Open 
Firmware prompt but is then unable to talk to or use the prompt to set the 
box to network boot.  It fails at "check for active console".  If I view 
the console I can see the Open Firmware prompt is displayed and if I hack 
LparNetbootExp.pm such that the code gets past this point then it still 
fails so looks to me like some sort of communication problem once the Open 
Firmware prompt is reached.

I have the latest xCAT 2.9 from the sourceforge yum repo installed 
(xCAT-2.9-snap201412080202.x86_64).  My management server is x86 RHEL 6.5 
and the compute nodes are Power RHEL 7.0.

Any hints for what I can check to get it going?

Thanks,

Graham

P.S.Verbose output of rnetboot follows...



rnetboot -V node01
lpar_netboot Status: List only ent adapters

lpar_netboot Status: -v (verbose debug) flag detected

lpar_netboot Status: -i (force immediate shutdown) flag detected

lpar_netboot Status: -d (debug) flag detected

node:node01
open port

spawn_id is 23268.

Connecting to the node01.

Connected.

Checking for power off.

Status: run_lssyscg : partition status : node01: Not Activated

####msg:node01: Not Activated#########

The lpar state is node01: Not Activated.

# Power off complete.

Power on the node01 to the Open Firmware.

Waiting for power on...

Check the node state again;
Status: run_lssyscg : partition status : node01: Starting

####msg:node01: Starting#########

The node state is node01: Starting.

Status: run_lssyscg : partition status : node01: Starting

####msg:node01: Starting#########

The node state is node01: Starting.

Status: run_lssyscg : partition status : node01: Running

####msg:node01: Running#########

The node state is node01: Running.

Status: run_lssyscg : partition status : node01: Running

####msg:node01: Running#########

The node state is node01: Running.

Status: run_lssyscg : partition status : node01: Running

####msg:node01: Running#########

The node state is node01: Running.

Status: run_lssyscg : partition status : node01: Open Firmware

####msg:node01: Open Firmware#########

The node state is node01: Open Firmware.

Power on complete.

Check for active console.

Timeout waiting for ok prompt; exiting.
Unless stated otherwise above:
IBM United Kingdom Limited - Registered in England and Wales with number 
741598. 
Registered office: PO Box 41, North Harbour, Portsmouth, Hampshire PO6 3AU
------------------------------------------------------------------------------
New Year. New Location. New Benefits. New Data Center in Ashburn, VA.
GigeNET is offering a free month of service with a new server in Ashburn.
Choose from 2 high performing configs, both with 100TB of bandwidth.
Higher redundancy.Lower latency.Increased capacity.Completely compliant.
http://p.sf.net/sfu/gigenet
_______________________________________________
xCAT-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xcat-user

Reply via email to