Travis Tabbal wrote:
After tweaking the config a little, yes. I can boot with pygrub using xm create and the serial console does work. No network, but it's also not defined with one so I expected that. At least I can get to the console now though.
What's different about loading it this way? Is there some way to convert this
setup to run under virsh?
For Debian Lenny its necessary to add
console=hvc0 xencons=tty
to the kernel line in /boot/grub/menu.lst
I think the Linux people changed it again but iirc the console is always
on hvc0
(worst comes to the worst you can just add a tty on hvc0 from /etc/inittab)
I found it easier to install a centos 5 and then debootstrap Debian from
that.(attach the disks with 'virsh attach-disk' or 'xm block-attach')
You can do that while its running pv. Its alot less painful than
installing hvm and trying to convert.
Sam
_______________________________________________
xen-discuss mailing list
[email protected]
