Mark -- i installed a Radeon 9K, it seems that completely fixed the video problem. FYI -- this is a Dell Precision 410 WS, two 450MHz cpus, 512MB DRam, Quantum Viking 10K (9GB) drive. the Dell box will only support 2x AGP, but that's okay for now.
i have a few small issues with RH9 installation, and am pursuing that through usenet. thanks for the help. At 21:14 10-06-2003 -0400, Mark Vojkovich wrote: > Intergraph did high end PC workstation cards before 3Dlabs bought >them years ago. I don't believe XFree86 ever supported any of >their cards natively, though it looks like there's a cheap cirrus logic >chip on the board for VGA compatibility. You can probably get that >working with some low resolution 8 bit modes using the CIRRUS driver >(try 800x600 in 8 bits per pixel), but that's about it. > > Really you're probably better off getting a newer video card. >While that card was probably pretty hot in its day, it's not likely >to hold up too well against modern video cards. www.xig.com might >have a commercial X-server that still supports this card, but I >suspect that for the cost of a commercial X-server you could buy a >card that's faster than the 3410T and is supported by XFree86. > > Mark. > > > >On Tue, 10 Jun 2003, jmw wrote: > >> hi -- >> >> i successfully installed Linux 9 on my Dell Precision 410 WS, and it seems >> that everything works except Graphics mode. a copy of the log is attached. >> from that, it seems that Linux cannot recognize the card. Linux was installed >> on its own disk. am i reading the log correctly? can you offer any suggestions? >> >> the video card is Integraph Intense 3D 3410T Pro, 16MB ram. >> -- >> j m w > >_______________________________________________ >XFree86 mailing list >[EMAIL PROTECTED] >http://XFree86.Org/mailman/listinfo/xfree86 _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86