I take that back, sort of.
The $DISPLAY in Terminal points to xquartz 2.6.3, is that the one that came 
with Lion?
It does get me a display though, so it proves it's not my servers at fault.

On Sep 28, 2011, at 8:08 AM, Daniel Seagraves wrote:

> Unless it somehow got disabled on every host on our network, that's not it.
> As a test, I opened Terminal next to xterm, and set DISPLAY in xterm equal to 
> what was in Terminal (/tmp/launch-LNnWLq/org.x:0 in this case)
> After doing that, ssh -XY works again.
> Maybe ssh is doing something unusual that causes :0 to fail?
> 
> On Sep 27, 2011, at 1:34 PM, Jeremy Huddleston wrote:
> 
>> 
>> On Sep 27, 2011, at 6:12 AM, Daniel Seagraves wrote:
>> 
>>> For some reason, I can't ssh -XY anymore. $DISPLAY on the Mac is :0
>>> The sshd on the remote side logs the message "channel 3: open failed: 
>>> administratively prohibited: open failed"
>> 
>> You can use '-vvv' to get much more verbose information out of ssh, but my 
>> guess is that your remote system doesn't allow ssh forwarding.  You should 
>> check /etc/ssh/sshd_config or /etc/sshd_config on the remote host.
>> 
>> 
>> 
>> 
>> _______________________________________________
>> Xquartz-dev mailing list
>> [email protected]
>> http://lists.macosforge.org/mailman/listinfo.cgi/xquartz-dev
> 
> 
> _______________________________________________
> Xquartz-dev mailing list
> [email protected]
> http://lists.macosforge.org/mailman/listinfo.cgi/xquartz-dev


_______________________________________________
Xquartz-dev mailing list
[email protected]
http://lists.macosforge.org/mailman/listinfo.cgi/xquartz-dev

Reply via email to