Hi Peter,
There isn't enough information here for me to help you.
Could you please list the commands and steps you used to build the image?
- what repositories are you using?
- what branches of those repositories?
- if you changed any config files, what did you change?
- what command did you run to build your image?
- what did bitbake print as your build configuration?
Which i.mx board are you using? There are dozens of them.
Best regards,
Trevor
On Fri, May 12, 2017 at 3:34 PM, pe...@gmail.com
<balazovic.pe...@gmail.com> wrote:
> I build on i.mx (NXP) machine, I want to get configured as dhcp (no
> static)...
>
>
> ------ Original Message ------
> From: "Trevor Woerner" <twoer...@gmail.com>
> To: "Peter Balazovic" <balazovic.pe...@gmail.com>
> Cc: "Yocto list discussion" <yocto@yoctoproject.org>
> Sent: 5/12/2017 9:32:17 PM
> Subject: Re: [yocto] dhcp eth0 network
>
>> Hi Peter,
>>
>> For what MACHINE are you building? What's your target hardware? Can
>> you summarize the steps you took to build your image?
>>
>> What do you want eth0 to do? dhcp or static ip?
>>
>> Best regards,
>> Trevor
>>
>>
>> On Fri, May 12, 2017 at 12:01 PM, Peter Balazovic
>> <balazovic.pe...@gmail.com> wrote:
>>>
>>> Dears,
>>>
>>> I got Yocto image and unfortunatelly network is not somehow enabled &
>>> proprely configured. After "ifconfig" no eth0 configured.
>>>
>>>
>>>> ifconfig
>>>
>>> lo Link encap:Local Loopback
>>> inet addr:127.0.0.1 Mask:255.0.0.0
>>> ....
>>>
>>>
>>>
>>>> /etc/network
>>>> ls
>>>
>>> if-down.d if-post-down.d if-pre-up.d if-up.d
>>>
>>>
>>> How should I setup "eth0" to get network working properly?
>>>
>>> Thanks.
>>>
>>>
>>>
>>> --
>>> _______________________________________________
>>> yocto mailing list
>>> yocto@yoctoproject.org
>>> https://lists.yoctoproject.org/listinfo/yocto
>>>
>
--
_______________________________________________
yocto mailing list
yocto@yoctoproject.org
https://lists.yoctoproject.org/listinfo/yocto
