On Friday 08 September 2006 09:14, Justin wrote: > Hi all, > > What problems did you have with VMWare Mark? I just installed it yesterday > and everything went smoothly enough (except I had to use CLI). > > Regards, > Justin
Hi Justin, Well, I tried installing Y 2.91 in VmWare and it simply refused to install. Always started - then fell over with an error about no partitions found. I have seen that before, so using another distro to pre-partition the (virtual) drive was my solution. But VMWare, by default, creates scsi virtual drives - and Yoper 2.91 doesn't like scsi drives. Once I spotted the error in Yoper relating to being unable to find the installed boot partition, I found out how to change the VM virtual drive to IDE instead - problem solved. Not sure how your install just worked Justin - unless maybe you have a later version of the iso? I think Tobias did some changes to get scsi and sata drives supported better. Mark _______________________________________________ yoper-dev mailing list [email protected] https://morpheus.pingos.org/cgi-bin/mailman/listinfo/yoper-dev
