Larry,
I think the problem is that your zTransportPreference is "ssh". It
should be "command"
-EAD
On Nov 1, 2006, at 4:53 PM, Brown, Larry wrote:
I followed the instruction in the administrator's guide to using
SSH to handle data collection and when I go to collect
configuration I get:
2006-11-01 14:42:36 INFO zen.ZenModeler loading collector plugins
from:/home/zenoss/Products/DataCollector/plugins
2006-11-01 14:42:36 WARNING zen.ZenModeler no cmd plugins found
for techrd-lnx.nmrcf.com
2006-11-01 14:42:36 WARNING zen.ZenModeler no snmp plugins found
for techrd-lnx.nmrcf.com
2006-11-01 14:42:36 WARNING zen.ZenModeler no portscan plugins
found for techrd-lnx.nmrcf.com
2006-11-01 14:42:36 INFO zen.Device collected snmp information for
device techrd-lnx.nmrcf.com
and that's it. No new data is reflected on any panel
( Status,OS,Hardware,Software, etc. ) So I'm guessing the "no cmd
plugins" is where it is failing? According to the administrator's
guide I had to set the following and have:
zCommandUsername: username
zCommandPassword: *********
zSnmpMonitorIgnore: True
zCollectorIgnorePlugins: snmp|portscan
zTransportPreference: ssh
I then saved and then switched to the Manage tab and pressed
"collect configuration" to get the aforementioned data.
One other note. There is relatively no elapsed time for the
collect configuration output to conclude. It doesn't pause like it
is timing out etc.
Larry Brown
_______________________________________________
zenoss-users mailing list
[email protected]
http://lists.zenoss.org/mailman/listinfo/zenoss-users
_______________________________________________
zenoss-users mailing list
[email protected]
http://lists.zenoss.org/mailman/listinfo/zenoss-users
