If the FS is tough enough to run from the NID to the biscuit and withstand
staples, tight bends and UV then it sounds pretty good. But I really like the
little metal bullet end on the pre terminated Miniflex. Easy to push through a
wall etc.
From: Carl Peterson
Sent: Thursday, August 13, 2020 11:34 AM
To: AnimalFarm Microwave Users Group
Subject: Re: [AFMUG] CPE Install Costs.xlsx
FS armored patch is different then clearfield pushable. FS has a 900um loose
inside a metal spiral with a PVC jacket. CFD pushable has a 900um in gel
inside a thick plastic jacket. You can't really push the FS with connectors on
it, or at all really. The FS is much more flexible and doesn't kink like CFD
pushable but you can't push it. I don't like CFD pushable outside of
microduct. Too easy to mess up and there are better fibers for the
application.
On Thu, Aug 13, 2020 at 10:56 AM Mark Radabaugh <m...@amplex.net> wrote:
Well, I have managed to put a staple through it if that counts :-) If you
don’t shoot the staple right through it it works fine - I just had bad aim.
And for what it’s worth the cable still worked. It’s at my house so I’m not
too worried about it. Hopefully our install crew uses a little more care.
It’s relatively stiff but it’s not like the Clearfield or other brands of
pushable fiber that have a very minimal diameter protected stub at the end that
you then assemble the SC connector to after pushing it in. You can get the
movable part of the SC connector to pop off but you still have the full square
end of the SC to deal with - it won’t go through most microduct, but you can
get it through the normal drill size you shove CAT-5 cable though.
Mark
On Aug 13, 2020, at 11:22 AM, ch...@wbmfg.com wrote:
Will this FS stuff take a staple and can you push it through microduct?
From: Mark Radabaugh
Sent: Wednesday, August 12, 2020 7:23 PM
To: AnimalFarm Microwave Users Group
Subject: Re: [AFMUG] CPE Install Costs.xlsx
I fhink you preterminated indoor jumper cost is too high. These
https://www.fs.com/c/armored-patch-cables-220 work fine for the inside wiring
from the outdoor box to the wall plate or direct to CPE if you are not doing a
inside jack. They are not UV rated so you have to make sure you don’t leave
them exposed outdoor. You can pop the outer SC portion off the jumper if you
want to pass through a smaller hole.
Mark
On Aug 12, 2020, at 7:00 PM, ch...@wbmfg.com wrote:
<CPE Install Costs.xlsx>
----------------------------------------------------------------------------
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
Carl Peterson
PORT NETWORKS
401 E Pratt St, Ste 2553
Baltimore, MD 21202
(410) 637-3707
--------------------------------------------------------------------------------
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
