Is Cat5 the default setting? So in recovery console mode you'd have the
Cat5 and you could get in on 169.254.1.1?
https://community.cambiumnetworks.com/t/how-to-enter-default-mode-or-recovery-console-for-450b-450i-and-450m-series-products/44936
On 4/22/2021 12:14 PM, Nate Burke wrote:
Not that I've found. It's a single drop down box to select the data
path, that's the only setting. I set it for Fiber, the Cat5 port
still has a physical link, but passes no traffic.
I unplugged the Fiber cable, plugged my laptop into the cat5 and
rebooted. I got a handfull of pings through, (maybe 5 or 6) during
the bootup process, then it stopped responding completely. I thought
maybe if it had no Link during a boot it would automatically switch to
the interface with an active link, but no.
On 4/22/2021 11:10 AM, Adam Moffett wrote:
I don't have a 450m....
Can you have both ports on with different IP's? Even if they're not
bridged at least a way to back door in through the second port?
On 4/22/2021 12:07 PM, Nate Burke wrote:
Oh, that's bad. A fully functional AP, hanging in the air, that's
completely unusable just because what should/can be redundant,
isn't, because of software.
On 4/22/2021 10:58 AM, Josh Luthman wrote:
It sucks. That's how it is.
If it's 5 GHz you can do it over RF. If it's 3 GHz you can't
because it'll have to reach a SAS to transmit.
Josh Luthman
24/7 Help Desk: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Thu, Apr 22, 2021 at 11:14 AM Nate Burke <n...@blastcomm.com
<mailto:n...@blastcomm.com>> wrote:
I'm getting ready to deploy my first set of 450M radios, from
my bench
testing, and reading through the manual, do you have to Choose
which
data path is active, Copper OR Fiber? And the only way to
switch it if
that path is down is to log into the Radio with an SM
connection over
the RF? That can't be right can it?
The EPMP radios bridge the copper and Fiber inside the radio so
both are
active. That doesn't seem to be the case with the 450M. Does
the 450M
only allow one data path, and if it breaks your SOL unless you
can gain
sudo-physical access to the AP? I have be missing where you
set the
primary/secondary data path, but I haven't been able to find it
yet.
--
AF mailing list
AF@af.afmug.com <mailto:AF@af.afmug.com>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
<http://af.afmug.com/mailman/listinfo/af_af.afmug.com>
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
