you need to change that steering wheel from silver to welded gold chain and get some 29 inch rims with spinners.
but i dont care for electronics under chassis, something always can get bound or crush a wire in a manner it doesnt look crushed On Tue, Jan 10, 2023 at 5:07 PM Jan-GAMs <j.vank...@grnacres.net> wrote: > I wouldn't put that in any area where weather could get at it. Just > asking for trouble. It needs to be sealed from moisture/condensate/water. > Perhaps half a ton of silicon grease temporarily? > On 1/10/23 09:59, Chuck McCown via AF wrote: > > I build a piece of industrial equipment. Currently the motion control PCB > is in the steering column. I am thinking of potting it and putting it > underneath the chassis. Easy to get to etc. But what kind of connector > should I use? Flying leads coming out of the potting compound into a > cannon type connector? Hate to use any connector that is non ip67, so > phoenix plugs are out. > > Not sure I am going to do this but we are kicking it around. I might just > leave it where it is. It has phoenix connectors now with wires and ferules > going to screw down terminals etc. > > Best Regards, > Chuck McCown > > McCown Technology Corporation > 8401 N Commerce Dr > Lake Point, Utah 84074 > 801-250-9503 Office > 435-830-4306 Cell > www.mccowntech.com > www.microtrench.pro > www.terabitnetworks.com > > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com