is ultraflex actually pretty flexible? We used to make our own ends, but theyre solder type ends they had us crimping on, and on top of it you can trust a tech knucklehead to secure the lead without cranking on it. i just want lowish loss leads with factory ends that are flexible enough to offset the nimrod factor
On Thu, Oct 9, 2014 at 2:19 PM, Chuck McCown via Af <[email protected]> wrote: > That is plenty long for 5 GHz. > It will work but you will have a loss of .29 dB per foot. > > *From:* That One Guy via Af <[email protected]> > *Sent:* Thursday, October 09, 2014 1:09 PM > *To:* [email protected] > *Subject:* Re: [AFMUG] ptp650 antenna leads > > short runs with the radio on the same pipe as the antenna less than 36" > in 5ghz > > On Thu, Oct 9, 2014 at 2:08 PM, Chuck McCown via Af <[email protected]> wrote: > >> Totally depends on the frequency and length of run. >> >> >> *From:* That One Guy via Af <[email protected]> >> *Sent:* Thursday, October 09, 2014 12:55 PM >> *To:* [email protected] >> *Subject:* [AFMUG] ptp650 antenna leads >> >> I hate lmr400 which is what we have always used. >> Is N-N LMR 195 lead sufficient, or what flexible leads are folks using >> for antenna connections >> >> -- >> All parts should go together without forcing. You must remember that the >> parts you are reassembling were disassembled by you. Therefore, if you >> can't get them together again, there must be a reason. By all means, do not >> use a hammer. -- IBM maintenance manual, 1925 >> > > > > -- > All parts should go together without forcing. You must remember that the > parts you are reassembling were disassembled by you. Therefore, if you > can't get them together again, there must be a reason. By all means, do not > use a hammer. -- IBM maintenance manual, 1925 > -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
