http://www.ebay.com/itm/N-Male-LMR-400-UF-Ultra-Flex-Lowest-Loss-RF-Jumper-Patch-Cable-Times-Microwave-3-/230781513328?pt=LH_DefaultDomain_0&hash=item35bba66e70
On Thu, Oct 9, 2014 at 12:26 PM, That One Guy via Af <[email protected]> wrote: > is ultraflex actually pretty flexible? > We used to make our own ends, but theyre solder type ends they had us > crimping on, and on top of it you can trust a tech knucklehead to secure > the lead without cranking on it. > i just want lowish loss leads with factory ends that are flexible enough > to offset the nimrod factor > > On Thu, Oct 9, 2014 at 2:19 PM, Chuck McCown via Af <[email protected]> wrote: > >> That is plenty long for 5 GHz. >> It will work but you will have a loss of .29 dB per foot. >> >> *From:* That One Guy via Af <[email protected]> >> *Sent:* Thursday, October 09, 2014 1:09 PM >> *To:* [email protected] >> *Subject:* Re: [AFMUG] ptp650 antenna leads >> >> short runs with the radio on the same pipe as the antenna less than 36" >> in 5ghz >> >> On Thu, Oct 9, 2014 at 2:08 PM, Chuck McCown via Af <[email protected]> wrote: >> >>> Totally depends on the frequency and length of run. >>> >>> >>> *From:* That One Guy via Af <[email protected]> >>> *Sent:* Thursday, October 09, 2014 12:55 PM >>> *To:* [email protected] >>> *Subject:* [AFMUG] ptp650 antenna leads >>> >>> I hate lmr400 which is what we have always used. >>> Is N-N LMR 195 lead sufficient, or what flexible leads are folks using >>> for antenna connections >>> >>> -- >>> All parts should go together without forcing. You must remember that the >>> parts you are reassembling were disassembled by you. Therefore, if you >>> can't get them together again, there must be a reason. By all means, do not >>> use a hammer. -- IBM maintenance manual, 1925 >>> >> >> >> >> -- >> All parts should go together without forcing. You must remember that the >> parts you are reassembling were disassembled by you. Therefore, if you >> can't get them together again, there must be a reason. By all means, do not >> use a hammer. -- IBM maintenance manual, 1925 >> > > > > -- > All parts should go together without forcing. You must remember that the > parts you are reassembling were disassembled by you. Therefore, if you > can't get them together again, there must be a reason. By all means, do not > use a hammer. -- IBM maintenance manual, 1925 >
