> not drastically cold today 18 and windy isn’t exactly warm, at least for whoever is going to climb the tower, if not for the radio
From: That One Guy via Af Sent: Tuesday, November 18, 2014 12:29 PM To: af@afmug.com Subject: Re: [AFMUG] ubnt test2.cgi stress test? no the processor time is idle prior to running the stress test. It runs the command /sbin/factorytest stress I forgot the process that pops up showing the processor time, im off the radio now. I wish there were a temp reading somewhere. It not drastically cold today, was just hoping to avoid swapping it out. but im programming up the new one now anyway. Its just odd. None of the connected radios show higher than 20ish pps max, i assume hardware failure at this point On Tue, Nov 18, 2014 at 12:16 PM, Rory Conaway via Af <af@afmug.com> wrote: I’m think the heavy processor usage might be your problem. Any chance you have a user with a torrent program going berserk? For a quick test, I would disconnect them one at a time for 30 seconds and see what happens to the CPU usage. Rory From: Af [mailto:af-boun...@afmug.com] On Behalf Of That One Guy via Af Sent: Tuesday, November 18, 2014 10:01 AM To: af@afmug.com Subject: [AFMUG] ubnt test2.cgi stress test? anybody know what this does? I have an AP that has 6 clients, 5hz channels, decent links for all, the AP is reachable fine, but the clients are all having throughput problems and most of the time are inaccessible Im wondering if the AP hasnt gotten too cold so Ive been trying to force it to heat up, running the builtin speedtest to the colocated AP browsing the /usr/www folder there is the test.cgi and the test2.cgi, test2 lets you initiate a stress test, I dont know what that does, but top shows the processor in heavy use. I assume this would generate heat. Does ubnt have any temp sensor? what does this stress test actually do? I do not want to climb up and replace this AP today, I left my heavy pants at home -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925 -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
