What if I dont have an existing dial?
This is a 50gal upright tank that just has a valve on top.
I was thinking they may have an inline sender that measure the amount of
pressure.
On 5/20/2015 9:42 AM, Chuck McCown wrote:
You take the dial off the existing gauge and install the sending unit
in its place. The dial goes back on top I think so you don’t lose the
local indicator.
*From:* David <mailto:dmilho...@wletc.com>
*Sent:* Wednesday, May 20, 2015 8:32 AM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* Re: [AFMUG] looking for a simple lp gauge
Does this sensor fit directly on the tank or inline with the hose?
On 05/19/2015 08:25 AM, Chuck McCown wrote:
http://www.rochestergauges.com/products/R6315-12.html
*From:* David Milholen <mailto:dmilho...@wletc.com>
*Sent:* Monday, May 18, 2015 9:16 PM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* [AFMUG] looking for a simple lp gauge
I am looking for a LP gas gauge that has a sensor for remote
sense in the measure of ohms to connect to a site monitor or possibly
the standby controller we have
to let us know the level of our LP tank.
ALSO forest,
If you would be so kind to tell me the secret rule for configuring
the exorcise rule for a 2 wire generator config.
When I set it up it either doesnt start at all or even trigger the
standby sequence. Other configs I have tried
will start it but it doesnt complete the cycle.
--
--
